Power Distribution (PDM) Solid State
The power distribution module is designed to allow a designer the ability to utilize the product within the ES-Key electrical system network to control distributed loads. The module reports the state of inputs and operating parameters to the network and will activate outputs on command from the network. All output channels of the PDM utilize solid state, fully protected high-side drivers that feature overload protection, current limitation, open load detection and transient protection. These output drivers replace the requirement of a relay and circuit breaker.
Power Distribution (PDM) Solid State
 
Features
Each of the outputs are capable of supplying 7.5 Amps Continuously on all outputs at 85 Celcious
The PDM modules have built in Flashers. These flashers can be set to operate at two flash rates - 75 pulses per minute, and 150 ppm. By using an alternating pair, up to 300 pulses per minute can be realized
Any output can be controlled ON at reduced power by activating its PWM channel
Three levels of load management for a particular physical output (ON, REDUCED, OFF) can be accomplished by shedding the output at one level, then shedding the PWM output at a lower level
Several combinations of I/O are available
 
General Information
Contact Class1 for more information
 
Part Numbers
104434 - 8 Positive Out (7.5 amp)
104528 - 6 Positive Out / 2 Inputs (selectable polarity)
104529 - 4 Positive Out / 4 Inputs (selectable polarity)
105071 - 4 Positive Out / 4 Negative Out